PRO100-BM side-mount: allow 1/2 inch +1/32 / -0 per side. No undermount rear notches. Nominal labels differ from physical slide length; use the manufacturer mounting-hole template.

PRO600 standard: exterior drawer length matches the selected nominal length. Exact rear notch, hook-hole centers and locking-device machining require the matching PRO600 factory template; not approved for machining from family-level dimensions.

TANDEM 563H: two rear notches, minimum 35 mm wide by 13 mm high, at the inside side-wall edges. Rear hook bores: diameter 6 mm, depth 10 mm; locate hole centers with the exact Blum drilling template, not the reference drawing. Recess the bottom underside 13 mm (manufacturer nominal 1/2 inch). Front locking-device pilot drilling must use T51.1901 L/R installation templates. Inside box width must equal cabinet opening minus 42 mm; use actual measured wall thickness when calculating outside width. Selected preparation is included in the published box price. Runners, clips and cabinet brackets are not supplied.

MOVENTO 763 standard, without TIP-ON: two rear notches, minimum 50 mm wide by 13 mm high, at the inside side-wall edges. Rear hook bores: diameter 6 mm, depth 10 mm; locate hole centers with the exact Blum drilling template, not the reference drawing. Recess the bottom underside 13 mm (manufacturer nominal 1/2 inch). Front locking-device pilot drilling must use T51.7601 L/R installation templates. Inside box width must equal cabinet opening minus 42 mm; use actual measured wall thickness when calculating outside width. Minimum inside width 170 mm with standard locking devices. No TIP-ON machining included. Selected preparation is included in the published box price. Runners, clips and cabinet brackets are not supplied.

Accuride 3832E: 1/2 inch +1/32 / -0 clearance on each side. No undermount rear notches. Nominal lengths are not the physical slide lengths; use the 3832E factory hole pattern and mounting setbacks.

KV 8450FM: drawer width maximum 24 inches; allow 1/2 inch +1/32 / -0 per side. No rear undermount notches. Use the exact 8450FM mounting hole pattern; its track members are not interchangeable with older 8450 slides.

Source: Common U.S. Drawer Slides Report, October 2026. Full-extension soft-close; 100 lb; common lengths 15, 18, 21 inches; thicker-side applications require exact setup verification. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.

Source: Common U.S. Drawer Slides Report, October 2026. Heavy-duty undermount, up to 170 lb; multiple configurations. Exact lengths and model suffixes pending. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.

Source: Common U.S. Drawer Slides Report, October 2026. Synchronized soft-close; 100 lb; multiple lengths. Report identifies 21-inch Dynapro variants; exact runner version and fit must be confirmed. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.

Source: Common U.S. Drawer Slides Report, October 2026. Synchronized soft-close; 100–132 lb class; multiple configurations. Exact lengths pending. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.

Source: Common U.S. Drawer Slides Report, October 2026. Soft-close concealed runner; approximately 75 lb class; exact lengths pending. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.

Source: Common U.S. Drawer Slides Report, October 2026. Full-access concealed runner; economy/value class; exact lengths pending. Nominal length alone does not verify slide-to-box fit. No model-specific machining is enabled.